סמינר מחלקה של איתמר ברטל - אידוי של נוזל הזורם כלפי מטה בשלושה צינורות מקבילים

04 במרץ 2024, 14:00 - 15:00 
פקולטה להנדסה  
0
סמינר מחלקה של איתמר ברטל - אידוי של נוזל הזורם כלפי מטה בשלושה צינורות מקבילים

 

 

SCHOOL OF MECHANICAL ENGINEERING SEMINAR

Monday 4.03.2024 at 14:00

 

Wolfson Building of Mechanical Engineering, Room 206

 

Evaporation of liquid flowing downward in three parallel pipes

Itamar Bartal

M.Sc. Student, under the supervision of Prof. Dvora Barnea and Prof. Yehuda Taitel

School of Mechanical Engineering, Tel Aviv University, Tel Aviv, Israel

 

Evaporating flow in parallel heated pipes may occur in power plants such as steam, solar, geothermic or nuclear power plants or in cooling systems such as electronic devices cooling and air conditioning systems.

Parallel heated pipes are used to enhance heat transfer due to their large surface area. However, systems of parallel heated pipes may be subjected to instability problems, flow rate maldistribution and oscillations that may impair their performance.

In the present work evaporation of liquid flowing downward in three parallel pipes with common inlet and outlet headers is studied theoretically and experimentally. Subcooled liquid enters an upper manifold, and the pipes exit is placed somewhat below a water surface open to the atmosphere. Evaporation of liquid in parallel pipes was mainly investigated in co-current horizontal and upward flows. Recently Hayat et al. (2022) studied the behavior of a system of two parallel heated pipes with an upper inlet header. They found that the static instability (Ledinegg) is not sufficient to predict some of the phenomena occurring in such systems since upward flow and oscillations of pressure and flow rates may take place in certain regions of inlet flow rates. As can be expected the degree of complexity of the behavior of three parallel heated pipes increases significantly compared to that of two parallel pipes. This is reflected both in the steady state solutions, where several steady state flow rate distributions may be obtained for the same inlet flow rate and in the various transient trajectories towards the steady state solutions. Cases of upward flow in one pipe and downward flow in the two other pipes may take place as well as upward flow in two pipes and downward flow in one pipe may occur for the same inlet flow rate, resulting in different oscillatory behavior.

 

Acknowledgments

Support for this project was provided by the ISF (Grant No. 1098/18) and Ministry of Energy (Grant No. 053-11-220).

Nadav Goshen-SINGLE-LAYER, ALL-METALLIC METASURFACE FILTER WITH NEARLY 90° ANGULARLY STABLE RESONANCE

סמינר המחלקה לאלקטרוניקה פיזיקלית

 

28 בפברואר 2024, 10:00 
Room 512 Software & Compute- Eng. Building  
Nadav Goshen-SINGLE-LAYER, ALL-METALLIC METASURFACE FILTER WITH NEARLY 90° ANGULARLY STABLE  RESONANCE

 

לו"ז יום פתוח בית הספר להנדסת חשמל

23 בפברואר 2024, 9:00 - 13:00 
 
לו"ז יום פתוח בית הספר להנדסת חשמל

 

Ilya Margolin-Enhancing Cancer Classification through cfDNA and Transformer Models

סמינר מחלקת מערכות - EE Systems Seminar

28 בפברואר 2024, 15:30 
Electrical Engineering-Kitot Building 011 Hall  
Ilya Margolin-Enhancing Cancer Classification through cfDNA and Transformer Models

Electrical Engineering Systems Seminar

Speaker: Ilya Margolin

M.Sc. student under the supervision of Prof. Noam Shomron and Prof. Shai Avidan

 

Wednesday, 28th February 2024, at 15:30

Room 011, Kitot Building, Faculty of Engineering

 

Enhancing Cancer Classification through cfDNA and Transformer Models

 

Abstract

Cancer diagnosis often faces the critical challenge of late detection and advanced metastasis, leading to complex treatments and high mortality rates. Liquid biopsy, a method for extracting cell-free DNA (cfDNA) from blood, offers a promising avenue for the early detection of cancer through the identification of biomarkers in a non-invasive and cost-effective manner. However, early detection using tumor-derived cfDNA presents formidable hurdles, primarily due to the challenge of distinguishing tumor-derived cfDNA in a normal background without complex sequencing or reference samples.

Transformer-based deep learning models, renowned for their sequence modeling capabilities, have achieved remarkable success in diverse domains. Particularly, end-to-end models demonstrate the capacity to learn significant features and exhibit enhanced robustness. In this study, an end-to-end deep learning method based on a transformer encoder was developed and applied to multiple clinical datasets containing raw genomic sequencing data from cancer patients and healthy individuals. To simulate ultra low-cost, low-coverage sequencing, the method was further tested on down-sampled sequencing samples.

For multi-cancer classification, our method achieved 79% sensitivity at 85% specificity. Using a breast cancer specific model rather than the multi-cancer model improved breast cancer classification sensitivity from 68% at 85% specificity to 86% at 85% specificity. While traditional cancer detection methods show a dramatic drop in performance with lower sequencing coverage, our method shows almost similar cancer detection ability across all tested depths.

Transformer based deep learning models show potential for direct analysis of raw genomic data. With sufficient training data, optimized models may approach accuracies needed for clinical use. Our results show the feasibility of detecting cancer at an early stage directly from cfDNA. Notably, our technique requires an extremely small amount of sequencing data. This enables the method to be scaled for widespread early cancer screening applications.

 

השתתפות בסמינר תיתן קרדיט שמיעה = עפ"י רישום שם מלא + מספר ת.ז. בדף הנוכחות שיועבר באולם במהלך הסמינר

 

 

 

 

 

 

 

 

 

היום הפתוח לתואר ראשון בפקולטה להנדסה באוניברסיטת תל אביב הסתיים, ואנו מודים.ות לאלפי המתעניינים והמתעניינות שהגיעו להכיר מקרוב את מסלולי הלימוד, המחקר והחדשנות המובילים שלנו.

אלפים הצטרפו אלינו, ולא נתנו למזג האוויר הסוער לעצור אותם.ן מלהגיע, לשאול, לחקור, ולהתקרב צעד נוסף להגשמת החלום שלהם.ן.

במהלך היום הפתוח המשתתפים והמשתתפות זכו להיחשף למגוון תחומי ההנדסה, להשתתף בהרצאות מעמיקות, להתרשם מפרויקטים פורצי דרך, לצפות בהדגמות טכנולוגיות ולבקר במעבדות המתקדמות של הפקולטה.

בנוסף, התקיימו מפגשים עם חברי וחברות הסגל האקדמי והמנהלי, לצד שיחות עם סטודנטים וסטודנטיות, אשר שיתפו מניסיונם.ן האישי על הלימודים בפקולטה.

תודה לכל מי שהגיעו על ההתעניינות, השאלות המעמיקות והמעורבות הרבה! הרצון לגלות, להבין, ליצור, ולשנות את העולם דרך ההנדסה היה מורגש בכל פינה בפקולטה.

אם לא הצלחתם.ן להגיע, נשמח להעניק לכם.ן את כל המידע הנדרש באתר שלנו ולהשיב על כל שאלה.

נשמח לפגוש אתכם.ן שוב בקרוב – בפעם הבאה כסטודנטים וסטודנטיות מן המניין, בדרך לעצב את העולם של המחר!  

עמודים

אוניברסיטת תל אביב עושה כל מאמץ לכבד זכויות יוצרים. אם בבעלותך זכויות יוצרים בתכנים שנמצאים פה ו/או השימוש שנעשה בתכנים אלה לדעתך מפר זכויות
שנעשה בתכנים אלה לדעתך מפר זכויות נא לפנות בהקדם לכתובת שכאן >>