EE Seminar: PAPR Reduction in Single-Carrier Modulation with Markovian Constraint

~~
Speaker: Yonathan Tate,
M.Sc. student under the supervision of Dr. Dan Raphaeli

Wednesday, March 23, 2016 at 15:00
Room 011, Kitot Bldg., Faculty of Engineering

PAPR Reduction in Single-Carrier Modulation with Markovian Constraint

Abstract

The peak to average power ratio (PAPR) characteristic of a communication signal is of importance when power amplifiers (PA) are in need. In such cases, the span of the signal’s power must reside inside the linear region of the PA in order to avoid signal saturation, which leads to both in-band and out-band interferences. When the PAPR is high, the average power must therefore be backed-off (BO) to avoid saturation, and in turn the transmission becomes more error-prone. Such difficulties exist for example in satellite communication, where single carrier transmission with high spectral efficiency is common.
In this work we propose a novel approach for shaping for PAPR reduction which on one hand achieves better PAPR reduction than known techniques, and on the other hand is practical in the sense of integrating well with modern iterative error correcting schemes, specifically turbo codes. The proposed approach is based on using carefully selective puncturing of ECC parity bits to achieve non-equiprobable symbol signaling, which is designed to reduce the PAPR. The proposed technique has been tested in simulations on a 16-QAM constellation with various data rates, and an overall gain of over 1.6 dB is demonstrated in some cases against non-shaped signaling.

 

23 במרץ 2016, 15:00 
חדר 011, בניין כיתות-חשמל  

Dr' Ori Shoshani סמינר מחלקתי

11 באפריל 2016, 15:00 
וולפסון 206  
0
Dr' Ori Shoshani סמינר מחלקתי

 

 

 

 

 

School of Mechanical Engineering Seminar
Monday, April 11, 2016 at 15:00
Wolfson Building of Mechanical Engineering, Room 206

 

 

Using Nonlinearity to Reduce Phase Noise in MEMS-based Oscillators

 

Dr. Ori Shoshani

 

 

Due to their inherent compatibility with semiconductor technology and their ability to fulfill device miniaturization requirements, micro-electro-mechanical-system (MEMS) resonating elements are an attractive replacement for quartz crystals in time-keeping applications. They offer fast-responding, low power consumption elements that are readily integrable with electronic circuits in fabrication.  However, as the dimensions of MEMS devices are reduced, resonator frequency becomes highly dependent upon fabrication variances and environmental disturbances that result in degradation of frequency stability.  Moreover, in order to satisfy signal-to-noise ratio specifications, these MEMS devices often need to operate at amplitudes where nonlinear effects come into play, which leads to further degradation in the frequency precision. This talk will provide an overview of frequency stability in MEMS-based oscillators and describe some recently developed approaches to enhancing frequency stability by addressing, and even exploiting, system nonlinearities. Specifically, the use of synchronization and zero-dispersion points in the resonator frequency response will be discussed, and theoretical conditions for optimal operating points will be introduced.  Experimental validation of the results, obtained from experimental collaborators in the Kenny group at Stanford University and in the López group at Argonne National Laboratory, will also be presented.

 

Bio: Oriel Shoshani received the B.S. degree in mechanical engineering from Ben-Gurion University of the Negev, Beer-Sheva, Israel, in 2008 and the Ph.D. degree (direct program) in mechanical engineering from Technion-Israel Institute of Technology, Haifa, Israel, in 2014, for which he worked on problems related to fluid-structure interactions. Currently, he is a postdoctoral fellow in the Department of Mechanical and Aerospace Engineering at Florida institute of Technology and a visiting scholar in the Department of Physics and Astronomy at Michigan State University. His current research interests include dynamics of fluctuating nonlinear vibrational systems and applications to micro/nano-electro-mechanical systems.

 

 

 

 

 

10/3/16

10 במרץ 2016, 15:30 
 
10/3/16

You are invited to attend a lecture

By

 

Oren Pe'eri

 

 

M.Sc student of Prof. Menachem Nathan and Prof. Michael Golub

Electrical Engineering, Physical Electronics Department

Tel Aviv University

 

 

Direct Reconstruction of Spectral Signatures in Optical-Digital Snapshot Spectral Imaging Systems

 

Abstract

This thesis is dedicated to a new approach in spectral imaging. We use an imaging system that includes a spectral disperser, a micro-lens array (MLA), imaging lenses and a monochromatic sensor that records a mix of spectral and spatial data ("spectral cube") in a multiplexed form. We develop a special demultiplexing algorithm for direct extraction of spatial maps corresponding to spectral signatures of interest from the sensor data. This "signature mapping" is based on prior knowledge of spectral signatures of specific materials and on the assumption that the original spectral cube consists of their linear superimposition. Direct extraction of the spatial map of signatures marks the areas where the original image is abundant in specific chemical materials. As such, it substantially reduces the data volume by a ratio of the number of wavelength bands to the number of spectral signatures. The developed method and algorithms are validated by computer simulation of the spectral imaging system with the aid of spectral cubes of real multi-spectral images of gas plumes.

 

Thursday, March 10, 2016, at 15:30

Room 011, Kitot building

 

 

 

עמודים

אוניברסיטת תל אביב עושה כל מאמץ לכבד זכויות יוצרים. אם בבעלותך זכויות יוצרים בתכנים שנמצאים פה ו/או השימוש שנעשה בתכנים אלה לדעתך מפר זכויות
שנעשה בתכנים אלה לדעתך מפר זכויות נא לפנות בהקדם לכתובת שכאן >>